How to replace the conveyor belt for the ZWY60 muck loader?
The oil and some parts of the mining ZWY60 muck loader need to be replaced during use, and the life of a conveyor belt is about six months. How to replace it? Raise the lift cylinder of the ZWY60 muck loader a little. Thread the new conveyor belt forward slowly from the back and bottom, and pay attention to the position of the front scraper that the belt is above the idler and below the front scraper. Then pull 4~5 meters away from the bottom of the slag scraper shovel mouth, and then pour it back, and wear it out from the driven drum before, and don't wear it into the rectangular tube.
Then pull the conveyor belt of the mining ZWY60 muck loader back, use a tractor or a person to put on the belt buckle and pull it back until it reaches the back of the drum. Remove the iron wire, connect the buckle of the conveyor belt, adjust the adjusting bolts, and adjust the conveyor belt of the ZWY60 muck loader. Just like when we wear clothes, either loose or tight, just right.
